This all started when I swapped out my small monitor at my CNC with an old 32" monitor (TV). When I turned the power back on my Spindle started on it's own and when I cycled the power to the CNC 3018 Pro controller it was then DEAD!
So at that point I ordered a new controller and decided to separate the CNC controller and monitor from my shared laptop dock in my electronics cave and run the CNC off of the laptop alone. Then I put an old PC Tower back together to run the software in my electronics cave.
I then milled a quick PC Board to mount a speed attenuation for my spindle and now I am ready to try to make some more complex PCB's again (still practicing and using lots of trial and error)
#CNC #3018 Pro #EasyEDA #FlatCam #Candle
10 сен 2024
