This takes you step by step on removing the panel to get to the window motor. The passenger side window wouldn't stay up - so we got a new motor via ebay for installation.
Great video... It was straight and to the point. Other than fiddling with the window for a bit, my buddy and I were able to replace the motor. Thanks!!
Nice tutorial buddy but you didn't show how to put the window back in place Plz can you make a tutorial about it Ill appreciate it thanks a lot for being the best
Hi Juan, I'll tell you what I'll put in on the list. Adjusting the window was a two man job so my camera man had to help me. A lot of people seem to be asking for this video so I'll see what I can do. Once the weather warms I'll be doing a video or two with the Z on some minor Mods (light bulb replacement etc.) Thanks for watching.
I believe my window camber is not set right. Auto Collision fixed my door from the accident. Motor works but it pushes against the top seal as it comes up. Thanks
same issue. only problm now is the glass seems to be loose. i can grab the window with my fingers and move it 2 or 3 inches up or down. but I tightened all of the bolts.
how were you able to fix this issue? my passenger side window goes up & down but seems like it's not sitting correctly as the window is not aligned correctly.
Looks like you could have just left the window and everything else in place and just removed the screws to remove the motor and replace just the motor and could have saved over half the time. And I see Nissan makes it easier to access by removing the whole panel so that you can easily access everything.
Hi Steven, If you have a shop you deal with on a regular basis they are probably going to charge 1.5 hours labor each side plus parts. But hey, if you're close to me bring it by and I'll install them for a hundred bucks each side :) Thanks for watching and good luck with it.
This could have been a very good video. But some of the most important parts were skipped over. I like the narrator, but when I research a project, I want to see the details.
first slide the glass in the run channel at the front of the door. gently lower the glass into the door. while doing that look thru the forward access hole on the black panel this will show thre plastic glass mount sliding into its perch on the forward regulator track. put the bolt in place but do not tighhten completly. thenalign up the rear guide bolt and tighten.
Do you have to raise the internal window mount to get it to the right height? I'm stuck. I've got the black panel back in place with a new motor and track assembly. I plugged it back in and turned the key, but when I push the raise window button nothing happens. I then hit the lower window button just whirs for a second. Then the up button again and it goes up about 1/8 of and inch and then drops back down and stops. I can't put the glass in because the mounts are too low unless I raise the assembly up a bit. At least it seems that way, unless I don't have the glass in the channel like I think I do.
Hey, I just saw this - all we did is put the power to the motor and adjusted the glass so the mounting brackets aligned up with the black holes in the panel.
hi Joseph.. installing the window was a two man job. My camera man had to hold the window in place while I put the bolts through the regulator. Hence thats why we didnt show it.
