Download the free AutoCAD practice drawing eBook containing the fully dimensioned drawing used in this video here: sourcecad.com/... A sample 3D AutoCAD practice drawing
Download the free AutoCAD practice drawing eBook containing the fully dimensioned drawing used in this video here: sourcecad.com/autocad-practice-drawings-with-pdf-ebook/
Please should have added dimensions to the actual drawings for it to be simple for us... Also try change the to vertical so that you can draw at one side and the image at the other side too...
Hello Jaiprakash, I really enjoy your channel on RU-vid, Thank you for these amazing tutorial video's..great job..looking forward for more..You help a lot of people by the way.. Take care..
Hi Jai, great tutorial once again. I keep getting stuck with the geometry at 11:35 into the video, i.e. the two extensions. The poly-line is closed. However, when I try to extrude I can't, I get the message about self-intersecting curve. I've tried different possible remedies, e.g, explode and join again, boundary - island detection etc, etc but nothing works. Do you have some suggestions ? I'm using version ACAD 2014.
This issue may happen if you fail to trim some "extra edges" from your drawing which can be seen by zooming the intersection points of geometries. Try to rim those extra geometries then repeat extrude with joined geometry. Alternatively you can also try using presspull instead of extrude in the geometry.
If you continue to watch video further you will notice that in order to create four circles of the geometry the extra length of 7 units was required at the end of line on the right side.
Hello, Many thank for this useful and informative video. Can you please share tutorial video for the 3D and 2D align command with examples. Looking forward to it. Regards.
Yes Imran you are right, I missed extra 7 units in the drawing which is shown on video but since the length of both lines are different you need to make one line longer then the other by 7 units.
hello sir , would you please tell us how to complete the drawing to the end , i mean to make all viewports (2d+3d) together in a table and adjusting the scale of each one , thanks
Hey While i join the object after selecting all the line and arc which i want to join a single polyline at but it can't join as a single object and i found 1 object discard from operation. Please give me a solution
Hello, I appreciate your help with your videos., When I went to modify, I didn't have extend up or down in the bottom tab..It says " Lengthen Select an object to measure or [Delta Percent Total DYnamic] : I was able to get around this by grabbing the endpoints and and pulling them 7 on each end. I just wanted to let you know. Thak you.