Just a test. Only part of the video. The cut sequence for the two 4-axis simultaneous swarf cuts might seem short. They are actually a bit long (with a small step-over), so I cut a bit of footage there. Hope you don't get too bored.
+shamu3838 Haha, thanks. If you look closely you can see I still left a bit of material on there where the tab is. One more operation puts a large hole through the part and ends up cleaning up that last bit.
can you show the program because I want to generate a program in Mastercam with a machine like this but I don't know how to make it because I don't have a lot of informations about the component and its G codes and M codes had been programmed in this operation in the forth axis.
+shamu3838 Yep, I've been looking for more info on 'em. Seems our HFO hasn't sold many. Salesman didn't have much info on it last I asked. There isn't too many videos on here either. Sure looks interesting based on it's specs though! Sounds like it would be a nice addition to your new machine. What would you use for workholding?
On this one a hole is drilled through on the next operation, so any burr left in the middle is removed. Otherwise, more care is taken when parting off to leave as little burr as possible. Yes usually a little clean up is needed.
