At full power (around 36J on .22 ) it's around 50 shots from max fill pressure till you start noticing important POI drop. I too 3d printed my own baffles with 7mm holes. 8 of them just 2mm longer each ... that really quietened down the rifle, not quite as quiet s your one but quite enough to be neighbor friendly. Also 3d printed trigger guard with over-travel stop regulation. I don't own any expensive rifles but among my cheapos this is my favorite: light, compact and reasonably accurate for it's budget. I did get a big headache when the popper valve cracked and started leaking but I DIY solved that and now it's up and running again with added benefit of polished hammer and valve spring tips, hammer and sear. I do get better accuracy from nine: about 25mm at 50m with JSB jumbo almost 16 grain ... maybe the rifle likes it better when shooting at around 265 m/s.
Picked mine up in the sale for £299. Quick clean of the barrel, slight adjustment of the trigger and it's spot on. Tinkered with the shroud internals and fitted a mini flat boy made by Bl4de.... it's as quiet as a mouse. Tweaked the hammer spring tension and use H&N FTT... run mine at 590fps, a spread of 5fps and std dev of 2.1fps. Shoots sub 20mm groups out to 35 yards. Mine's a keeper 👍🏻😂 Great channel 👍🏻
You probably bought yours in the same sale I did. Certainly lends itself to some tinkering. I think mine could do with a bit more power. All the best! 🙂👍
This gun performs best at 200bar, the REG is of a basic design and does not like full pressure, treated correctly these will match any PCP on the market below £1k.
mines putting pellets through the same hole at 30yds if i do my bit but i polished the barrel and recrowned it to achieve the accuracy.When i bought it the crown looked like it was done with a hammer and chisel.
@hftshooter Not blaming you for anything, just pointing out a stupid design that can lead to stupid behavior. It violates the first rule of firearms, never point it at anything you don't wish to kill.