4g63 Engine assembly [4k] 

Great work taking this on, i had mine done by a builder and i did the pulling and installing, did a squirter and balancer delete too, oil pressure runs from 80 to 100 psi which scared me but two years and still going fine

Randomly showed up in my feed, hands down nicest video i have seen in a while! Stoked to see more, keep it up!

I think you’re supposed to use a thread locker with the studs. I think ARP has a specific thread locker. The bolts should have a specific stretch and you don’t want to increase the stress on the threads in the block. Basically all the block thread stress should happen because of the tightening of the caps to the block, therefore you only do hand tight (10-25 in-lbs) on the studs and full torque on the nuts. Edit: Only put lubricants on the threads if specified by ARP. Lubrication impacts the bolt stretch and can double the clamping force at the same torque spec on any bolt. Checking the ARP instructions it looks like they do specify to use the assembly lube on the threads.

end play you can still check even when the engine is assembled.