Will you install a short shifter like yours on my 2014 Nissan Sentra 6 speed for a price? You did a great and professional job and a concise tutorial presentation. Thanks!👍
gasp! clearly you do not understand the sentimental significance of that claw hammer. It has constructed over 100 homes with Habitat for Humanities. It will be forever cherished and loved and certainly not chopped in half! .... also, any excuse to buy a SnapOn 20oz deadblow hammer, purchased literally right after this install.
The pins are the worst part and you need a good hammer to get them out. I used penetrating oil after i heated it up a wii bit a torch. Careful there is a rubber seal under the shift linkage on the shaft.
Remember mm of pin? You recommend to take out both pins? I saw you struggled a little to make the outter pin enter in the new model... Should I buy another pin instead of using the same?
I don't remember the size of the pin, but punches are sold by the set so that shouldn't be a concern. My only 'new' advice is to use the shortest appropriately sized punch paired with a palm nailer to make removal as easy as possible.
Well my rollpin was completely seized. Tried to drill it out, drill bit snapped inside. So now I have to drill out the drillbit and the inner pin. This install is awful because this design is just garbage.
watch the video. don't get frustrated. drill carefully and correctly. use proper tooling. walk away as necessary. but most importantly: get offline. you'll get it eventually. or you won't. either way, it'll be okay.