4L60e to 4L80e Wiring & Tuning 

Haha nice honestly I had to look him up.

Thanks guy! We are in the minnesota area

I used a dip stick out of a van and did some minor bending to get it to fit. 2007 fullsize van i believe

www.ebay.com/itm/185186275116?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=U6sZa8jDTwC&sssrc=2349624&ssuid=G2YjFL52T-i&var=&widget_ver=artemis&media=COPY

It was ok but I ended up repinning my connector and the conversion harness was repinned so it was an extension instead.

Some say its possible I havent tried though. If it was temporary then it could work but longterm not so much. The torque convertor locks up different and the shift points are different due to the different gear ratios from 1st to 4th. It should only cost you about $100 if you have hptuners. If not check out ebay and get a pcm someone flashed already they are all over ebay.

10/4 thank you.

@@TheJeffe613 no problem guy

Well there are two and if you remove either one the trans wont shift right or at all

@@southerngearz shift right or hard shift cause mine has a lock 🔐 up wire issue I tried everything except the tcc to brake rig trick

So if you go with the tcc to brake find the wire that gives 12v when the brakes are pressed. In my case when I was missing one of the speed sensors it was stuck in 2nd gear.