4link Done, Hardbody makes its way outside for some fresh air. 

😄 I look at it like, I know it's there, so why not make it look good. It's the same with hardware. Did I really need to get all new hardware for the mounting tabs that run under the truck for the brake lines and fuel supply? Probably not, but it would have bugged me. Lol. I appreciate you watching the videos. Hope you are enjoying the build.

Definitely! I'm enjoying the build a lot! I currently have the whole interior torn out of mine to run all of my door and window wires, relays, etc...Watching your videos is inspiring me to get out there and finish mine!

🥹 Thank you! That made my week! Would love to see your build as well! I've got old school roll downs in the King Cab, but we're going to do door speakers and route the wiring for the door popper solenoids soon. So I feel your pain there, lol

No...Thank you! I had the manual windows in my King Cab too and one of the guys on here told me about the Pathfinders being a direct bolt-in. So I found a pair on a '94 and bolted them in. I was going to grab some aftermarket switches from Summit, but I held off. I like to try and modify things and make it look factory. So I finally found my switches in a '02 Frontier Crew Cab, I grabbed the 2 from the rear doors and then installed them where my window cranks were. Turned out great and they are factory. I did have to notch about an inch to clearance the inner door structure for the switch to clear. I also got the Autoloc one touch up/down modules. I got spoiled driving my friend's car with that feature...Yes, wiring is a tedious endeavor especially when you don't like to do it. I just pulled my harness apart on my KA24DE powered Datsun 620 and eliminated every unnecessary wire, that took me a couple of weeks...The results were worth the pain!

It definitely sounds like a fun time! I figured the less wiring I have to do, the better, lol. If you look back at some older videos, the wiring on this thing was straight up a fire hazard. But had I not found the issues, and just cleaned up the truck, it probably would have burnt to the ground. Lol

🫡 Thank you, I can't wait to get it all finished up. But I'm starting to see the sculpture in the marble.

Yeah, I definitely plan on doing a bag over axle setup, but that will be later on if we back half the truck. For the time being, this current setup will be fine for meets and cars and coffee events. The plan is to go with either a 3 link or keep the reverse 4 link and just change the location of the rear bags. I definitely agree, tho that was the cause of the separation before. However, the previous welds were not all that great either. Lol

@@H.N.N.AutoWorx right on, keep up the progress!

@its_just_chad absolutely. I'm down for a few days with a broken tooth, but I should have a new video out next Saturday.