5 Maintenance Tips for Old Royal Enfield Bullet 350 l You Never Heard Before 

Yes Bro, we can wash it at Home.. Only the Pressure wash we should not do....

@@BulletRiders Thank you so much bro. I'm a very big fan of you😊

Thank you so much Bro..

Hi. Bro i didn't understand amp meter point. Can you please help me out with this

@@SHAKTISINGH-jk5mx bro old bullet la amp meter denotes the position of piston (that is in which stroke) Piston suction stroke la irundha tha kicker return adikama bike start aagum. Suction stroke la irukum bodhu amp meter needle straight ah irukum. Vera edhachu stroke like compression stroke, etc... la irundha needle straight ah irukaadhu. Left or right la irukum. So left or right la irukum bodhu decompression lever press panitu kick pannum bodhu piston vera stroke ku change aagum. Apo suction stroke vandha udanae needle center ku vandhurum. Then kicker use panni bike start pannanum. This is the proper way to start a cast iron bullet. I think you can understand the basic usage of amp meter.

Thanks a Lot Bro..

Thank you so much

Thanks a lot Bro

Thanks Bro

Thanks a Lot Bro....

Thanks a Lot Bro..

Thank you so much Bro..

Thank you Sir..

Thanks a lot

Thank you so much Bro

Definitely Bro

Hi Bro, 1) First Check whether FC is in Current and then the Life Tax, Green Tax & Insurance particulars.. 2) Check the Engine no and Chasis no particulars in the bike whether it was same as per paper.. 3) Try to procure from ur nearest Well known Mechanics (or) Workshops.. 4) Suppose if u are choosing a Models like G2s and B1s, then please pay more attention to verify and confirm whethers it's an G2 Bullet.. Bcoz in most places they are Selling(Cheating) 1980s & 90s models as G2 Bullets so please be careful with it.. 5) Old Bullets are the only machines where u can experience the Real Bullet feel and the new models are mere a normal bike.. 6) In New Bullets, you can Rev it hard which we can't do it in Old Machines so choose wisely..

@@BulletRiders really appreciate it brother . You just earned a Sub 💕

Thank you so much Brother..

Bro, first of all thank you so much for ur Comment.. Regarding ur issue, i will discuss with my Mechanic and i will come back to u with a solution.

@@BulletRiders Appreciate it chetta...

Ok Bro

Thanks a Lot bro.. Actually the Warm up time depends upon ur oil level bro.. If it's normal then 2-3 mins is enough but incase if it went down atleast it will take 5mins..

Thank you for your reply

It's not a Custom made... Bought from a local Merchant 5yrs back while restoration and i couldn't remember the cost..

It's a stock one Bro..

U frame

@@polgogoi268 not a U Frame bro... U frames comes in G2

No need Bro..

Place bro

Bro, i use to maintain 25 psi at front and 35 psi at the Rear

@@BulletRiders As per manual its 22 for front and 30-32 for rear, Mine is 1977 Bullet

So far i never felt any hand pain bro..

For best comfort I found RD 350 handle is very good. I have used both stock and RD 350 handles! for sake of originality I have reverted back to stock handle!

He wouldn't have understood your language. His bike's bend pipe is stock. Old model CI engine mein yehi bend pipe ata tha

Yes, we need to stop the engine by using decompressor and that is the correct procedure..

@@BulletRiders This will ensure no fuel residual is remaining inside combustion chamber and next time bullet starts immediately.

Yes Bro.. Old Bullets are also Capable to go for Long Rides but you need increase the speed gradually (or) Better to maintain it at 60 to 70kmph speeds..

@@BulletRiders okey thank you for your concern. Whats the mileage it gives ?

I'm getting 35 to 36kmpl

Enters from oil filler cap while washing, Never pressure wash your bike, I always cover the cap with polythene and rubber band while washing (bucket method). same for CB point.

Bro, first of all very sorry for the delayed reply.. Regarding the oil leakage, first u must check from where it occurs.. Whether from Drain Bolt (Or) Packing (or) Timing case and do the needful..

dont put fiber washer...use steel washer ..below engine bolt

@@melvinbritto1765 Shouldn't those be Copper Washers??

Yes bro.. It's capable for long rides.. There are lot of vintage bullets still doing Ladakh..

if you did engine overhaul with a good mechanic, this bike can take you anywhere.

Offcourse!!! Maintain it properly n it will tk u anywhere...

After 50Kms Bro..

Thank you bro

Illa sir, our channel won't indulge in sales. Plz check with ur local mechanic..

Buy one...find one, pay money and u are the owner!!!

It's a Stock one Bro.. Comes with the bike itself..

@@BulletRiders ok Brother

Whose stopping you??? Drive full throttle and make sure speedometer is working, don't forget to wear helmet and make sure brakes work!! Cheers

1986 Model

It's unusual... Clean the spark plug for every 15days once... Starting problem will most probably sorted out..

1986 Bro

@@BulletRiders nice one U tuk second hand or fresh

It's my Dad's Bike Bro.. We own it right from the beginning..

@@BulletRiders thats nice... Love from kerala

Thanks a Lot Bro...

Chalao toh chalte hain!!😆

To avoid Battery discharge..

@@BulletRiders but center stand on the ground AND center stand on a wooden piece.... What's the difference in relation to battery discharge?? I own a machismo 500

@@kalpeshpatole2880 Bro, Battery discharge will occurs only when it has been grounded so stand is the only thing that has the contact with the ground.. If we keep some wooden plange or something else discharge won't occurs... Whereas Tyres are the resistive path

@@BulletRiders that's a great tip... Thank you... Will this also work in monsoons as there is no roof over our parking space??

@@BulletRiders Why not remove the battery terminal if its to be parked for longer duration. Making it stand on wooden plank doesn't make sense. if the battery is discharged then there is a parasitic drain in the circuit

Bhai usko jo language aati hai wohi bolega na??? Ab aapko koi language nahi aati toh isme woh kya kare!! Seekhna behtar hai kisi aur ko seekhna bolne ke liye!

Bhai aap school nahi gaye?? Ab aapne koi doosari language nahi seekhi toh usme baki kya kar sakte hain?? doosro ki izzat karna seekhein, kamiyan na nikalein!! khud seekho

Haan nahi aati hogi!!! Toh? Apko angrezi nahi aati kaya? Bacchon jaisi baatein na kiya karo...doosron ki izzat karna seekho pehale!

Apko angrezi samjh nahi aayi??? Angrezi seekhne mein sharam aati hai kya? Kya bacchon jaisi baatein karte ho !!! grow up bro!!

Before commenting on others language did u even though he spoke a universal language....jo aapko samajh shayad nahi aayi. Ek aur language seekho!!!

Thanks a lot Bro..