6.0L LS LQ4 swap to a 4 speed Muncie SM465 MANUAL TRANSMISSION square body Chevy K20 Silverado 

doing good job keep it up

New subscriber bro🔥🔥🔥

Great video 💯! What is the part number for those flywheel bolts ?

Thank you so much.

And don’t forget to use brake clean on the flywheel before installing the clutch disc. Finger prints and grease on the flywheel will make your clutch chatter.😂

Does the stock sm465 bell housing bolt to the ls

who tuned your pcm and did you have to have a VSS?

Have you ran the set up yet with that pilot bearing and if so have you had any issues Or further recommendations

What year LQ4, and can you explain how the ALL26112 spun on the shaft, I’m confused, I know the the 6.0 LS had two different size shaft the pilot rides on based on the generation, I’m currently doing this swap with a 2002 LQ4 into a 1978 with the sm465

When putting engine in did you have to do anything for oil pan clearance

Were you able to bolt it to the ls while using the factory input shaft and small block chevy bellhousing on the muncie?

Did you use a swap oil pan or did you make the aftermarket pan work?

What are you using for throw out bearing/slave cylinder?