'93 GMC 1500 Pickup Brake Master Cylinder & Brake Booster Replacement (How to Bleed Brakes) 

Little tip to make this a little easier 1. When taking the clip off, un bolt master cyl. So you can depress brake petal fully and the clip will pass into your vision and you can take it off MUCH quicker without getting pissed. 2. If you don't have power tools use a flex head ratchet 3. If brake lights stay on for no reason when completed there is a sliding switch on brake sensor, slide the switch away from the firewall. 4. When getting top right bolt out remove the plugs from the steering angle sensor you get more range of motion. (ABS vehicles only) Amazing video just wanted to add a few things.

Awesome video only two tiny tiny comments 😆 1, when bleeding brakes only need to step on the brake twice n hold the second time 😊 When over doing the pumping of the brake pedal is actually a very bad the air bubbles are been broken into many many more smaller ones harder to move😁🙈 2nd when replacing the master cylinder was only 1/2 way done After bench bleeding n installing the two lines They break into 4 if you remove the dust cover You now see the nipple to bleed the master cylinder😁.

Thank you for this, Doesn’t look too difficult 😁

thnx vato for the video it really helped me out

Good video bro my is 95 kind of the same procedure,this video helps a lot Peace out ✌️

Thank you

What size are the 4 inside nuts

video is not woth when your covers it.