A Frame Home Using Floor And Rafter Beams With T&G 2x6 Sheathing - Plan #2 Framing Assembly Design 

This is what i was looking for!

Can you make a video on adding a loft on top of the collar ties along with a ladder or stair option? I would also like to see dormers added. Love this series. Thanks for the effort.

I have been watching your videos on and off for years. Thanks for making them, always learn something.

Thank you so much for sharing your knowledge in such a wise and kind way ! :)

You're a legend. Keep up the good work👍

Thank you very much, from the bottom of my hearth, : ) great jod on the modeling and edition.

out of all the hundreds of videos on youtube of people building Aframe houses, ive only seen one person who built theirs using a ridge beam at the top. And thru the whole video he struggled greatly doing so. He aslo stated that h would never do that again. Most people build the A frame on the ground then lift it in place. one thing here though that I dont see much if any and thats people spacing the A's at 4 ft on center. I think that makes a lot of since. On the ridge beam though they mainly use 2x4's for cladding at 2 ft on center from bottom to top then install their roofing. which is mostly metal roofing. great video though.

Hi, First off I would like to say your videos are top notch. The best on you tube. Second I would like to ask if you can do a video on the hardware for this type of building. Thank you so much.

What is the size of the rafters? Can you make a video on how to add a dormer?

5X the snow load if you put the outside concrete piers under EVERY rafter end

can you include visual dimensions with these drawings

Thanks for this video. I'm working on a 1960s A Frame similar to this. It has 6 inch rafters, 48" on center. I'm considering adding additional framing to accomodate shiplap on the inside of the roof. Wondering if I should add additional 2 x6s or do 2x4 framing attached to the existing rafters.

How long are the roof rafters for 18 ft wide ? 22 ft to get 66 deg ?

Without dormers or skylights I would guess the %glazing to floor area would be low and very limited natural lighting (dark inside during the day).

I would like to create or see someones cost comparison between vertical wall with roof vs A Frame design method. I would expect some adjustments for useability of the interior space. For Instance a 8 x 12 conventional shed with 8 ft walls vs a 12 x 12 ( floor size) A Frame. or maybe a 12 x 14 A-frame would be needed for an equal interior "useability" factor. The point is that A Frames may or may not be a more efficient design for true useability. That is what we have to figure out.. For some purposes the super high loft space of an A Frame might be of higher value but then also a loft space can be built in a conventional shed as well. The point is I really dont know for sure which is the more efficient design. Becaise there are many storage shed builders that stick to conventional design I tend to think the conventional design is most cost effective.

Are the roof rafters 2x8s? or?

thanks so much for sharing. I have two questions, please. Is there a disadvantage to putting the flooring down and then set your rafters? Is there a disadvantage to use a gusset plate at the top to connect the two rafters? Thank you.

Do you create Complete Building Construction Drawings in metric for customers?

Can you make a video on an A-frame house built with a T&G roof BUT Plywood floors instead? Thank you.

Where can i find the blue prints?

What would it take a roof not to be made with ridge board or beam, because I believe what I saw at my roof the rafters were just joined at the top?

Could you do a flat roof low slope video please!