A quick scroll saw project 

Thanks man! These pegas blades work very well and last a long time the only downfall is I find them noisy while cutting but no biggie ;) thanks for watching

Mike Fulton thanks mike i was shooting for a shadowed look lol i think it worked ;)

+oldman719 thank you!

+Kyle Patrick (fenderhead23) Thank you kyle its comments like yours that inspire me to do the videos

Patrick's work shop thanks patrick! good to see you around again buddy

Thanks mark I think I finally got the saw set just right ;)

Thank you!!

Thank you sterling ;)

Thank you!

Thank you! The blade I use is a #2 pegas reverse tooth...thank you for watching!

Thank you :)

btw, what type of wood were you cutting?

Thank you

+Red Beard Carpentry & Woodworks it was pine thinned down to 1/2 inch

MRrwmac i just crank up the speed on the saw and go to it... and believe it or not most of the time if i break a blade its cause i ran it to long and it was simply worn out but never from turning the wood piece

And lots of Practice @@TrevorsWoodShop

The wood I used for this project was 3/4 inch pine which is really soft and easy to cut and not to mention where I live is very cheap to buy ..when I look for different wood to work with I look for knots or grain marks that will compliment the project I'm doing at the time ....thanks for watching and sorry for the late reply 😀

+Trevor Carter no I'm so thankful, I am a young teen who wants to get into woodshop. thanks for helping me and responding, and don't worry about being late, even though the video was older you still responded and I am so greatful for that.

+shaman garcia It's great to hear you are getting started woodworking 😀 I'm not a pro but if you have any questions feel free to ask I will help all I can! 👍🏻

+Trevor Carter thanks so much

Thanks jay

Hi Dave I believe I got that one on scrollsawvillage dot com under animals tab in the free patterns and if I remember right their are 5-6 different ones .....thank you for watching

haroun timol sometimes if I notice the wood is gonna be unstable if I cut on the lines I'll just cut off the lines a bit so it leaves the wood a little thicker in that area....remember once you peel off your pattern no one will ever know you didn't follow the lines perfectly 😉 thanks for watching I hope this tip helped

+Larry Shoemaker thank you and yes the pattern is available on scroll saw village dot com under animals tab ....thanks for watching

Faesal Rahma Wiguna they are fun and very addictive lol thanks for watching 😀

They are fun. I have the same saw.

Thank you! I used a small wooden dowel to hold this in place..it stuck up about an 1/8" from the base just enough to glue

Rich Homie Navy I used a #2 reverse skip tooth blade from pegas

Your welcome ;)

nadela castro I just use printer paper then use packing tape over top

Bartosz Szady dewalt DW788 thanks for watching😀

thanks :) sad that its 110v ;p in poland we have 230v ;p

Bartosz Szady hawk

Trevor Carter , .

Thank you for watching, I found this pattern and a lot more just like this one on scrollsaw village dot com under the animals tab

+Trevor Carter thanks alot i found alot also i check tribal tatto ther is also many. Greetings from Poland :)

I agree, I need some new tunes thanks for watching