AddDoFeed - Small diameter high feed milling solution 

Thank you for liking it!

Thank you so much for your very kind words!

칭찬의 말씀에 감사드립니다! 그렇게 말해 주시면 매우 기쁩니다!

Thank you for your comment. What do you mean by that?

​@@TungaloyCorporation surely he's being clear, he's saying that you're deliberately running your competitors tool at an unreasonably slow speed to create an unfair comparison

お褒めのお言葉ありがとうございます！

Thank you for your good comment!!

Thank you for your precious words!

@@TungaloyCorporation not a better finish just a better picture

Toop

It's a roughing tool. Surface finish doesn't matter.

High feed end mills don't really need that much power, however you really need machine with high feedrate and acceleration to utilize their full potential.

@@Stasiek_Zabojca 10.tysiecy posow max maszyny będzie ok czy za mało? Wrzeciono 8 tysiecy rpm

コメントありがとうございます！ そう言って頂けますと大変嬉しいです！ 特に推奨はなく、基本的には皆様がご使用のチャックで問題ございませんが、 小径工具ですので、大きいチャックですとコレットなどが必要になる事もございます。

Time=money

They don't. It's quite surprising actually

They don't. The force is almost 0 Newton on these.

Processing can be done under higher conditions. Spindle speed 5500, feed/tooth 0.8, depth of cut 0.3

​@@TungaloyCorporation thanks for coordinating, and what percentage of engagement do I use in general. For say, maintaining outer dimension of plate.

😊👍⭐️

@Janus Fu Thank you for your comments. If you need help please contact to Tungaloy China. subs.tungaloy.com/cn/ Rm No 401 No.88 Zhabei, Jiangchang No.3 Rd, Shanghai 200436, China Phone: +86-21-3632-1880 Fax: +86-21-3621-1918

コメントありがとうございます。 今回はBT30で加工を行いました。

It's not even hard steel or something! Unless they were demonstrating high overhang cutting data for the solid end mill, like you said any end mill would just smoke it. Even on a horsepower limited VMC (11kW spindle) I have run cuts of 20mm deep, 8 mm wide at 165m/min (it was near maximum horsepower already) and 0.075mm/z with a 12mm 4F end mill enough times.

Grazie per il tuo commento!

This is not a chattering surface, but a machining surface unique to high-feed machining!

What is the part? There is no part that is particularly strange.

Machined surface is unique to high-feed machining. This is not a chattering surface.

Thank you for your comment!