Air Cooling miners to Immersion Cooling: How to remove fan, deep cleaning and install fan simulator 

I had thought you need to use an ultrasonic cleaner before immersion. Is just removing surface dust sufficient? What about the embedded dust/dirt which is not currently loose? Won't that come loose or dissolve into the fluid?

Is it ok for the fans to run inside the immersion cooling oil for KAS Miner KS5 in C6? If not why not?

Can we use immersion cooling for S19 K Pro 120 th with out reduce miners fan means put miner with fan in oil contener??? Yes than why?? Or no than why?? Please tell me

How about fan for the power supply?is it need to use fan emulator for power supply fan?

lovely looking system but is it affordable in the uk

cool

Hi, I'm looking for the same instruction for IceRiver KAS KS3M, any chance to have one? Does that device need a fan emulator? (I guess there's no overclocking firmware yet for it)

where is a good place to get the Fan Simulators

the lack of noise is a big plus for me , the only thing that kind of holds me back is wat if the miner breaks down and you need to repair an asic on one of the boards , by lifting it out of its tub the thing is now a greasy mess once you take it out and is dripping everywhere so put it on a rack over the tub and leave it till its finished dripping ...... that be about 3 hours lost mining allready and you havent put a screwdriver on it yet ok quick walk to the bathroom where you at least can flush the oil away intoo the showerdrain .....how do you flush the machine from the oil still sticking to it after that to get rid of most of the oil before taking the screws out whout getting filty up to youre armpits and getting greasestains on everything you tough (need to go to the bathroom , better plan in advance) will the tin still flow on the chips and the heatsink as it would be pretty contaminated will alcohol be enough to spotclean the surface and with the upgraded bigger heatsinks will the termal paste desolve in the oil reducing the thermal connection to the heatsink allso before inmerging the wole thing you probably need to take off the important labels (serial numbers etc ) stick to the housing as they probably peel off after some time inmerged since im planning to use an antminer the housings are the same throughout the range , might take the boards from a new miner out of its housing and put it in a used housing storing the new one for when its time to sell and then drop it in the oil that leaves the outside at least looking like new come to think of it , might be a market for housings that are watertight to be used both for mounting everything intoo but allso as the tank basicly an enclosed housing with gaskets and a entry and exit bung for the oil

Immersion cooling option available in S19K Pro 120 th ??

can i use this system gpu minning

i want to buy in Pakistan can u deliver.

Yikes that is one dirty machine 😲