I've now fitted a Cobb Redline Carbon Fibre Intake to the car and have a new similar video on my channel for it, might be of interest if you're keen to compare the sound & performance to a proper CAI intake!
Dont block the hole, get a quality aftermarket filter and you 100% can hear the difference. (09 foz sh5 XT) Note: remember hole if going throught high flood water
I had a 2006 Foz XT that had a silencer delete and a cone filter mounted down low in front tof the driver's side wheel and there was loads of amazing turbo flutter. I wonder if a previous owner had also blanked off the BPV.
nice video! I went stage 1+ on my 2020 STI and the induction noises are amazing! I hooked up some mics in the cabin and made a few videos on it already. I'd say it's about 3x louder than the intake silencer mod you did. Check the vids out. I think it's worth going Stage 1+
@@BenCad Hello 🙋, I got a question, I removed the air duct, resonator and filter housing for cleaning, I noticed small holes in the resonator and filter housing so I filled them with silicone. What is the purpose of these little holes, and if I seal them would it be a problem? Please, answer me 🙏
@@omartakhaineh3943 hey Omar, I think I know what you’re talking about. Eg there is one tiny hole at bottom of the silencer. I’m not an engineer but I’ve assumed it exists to let out small amounts of water and any particulars that may fly into your intake while driving.
Which means worse mpg, more revs, and more wear on your car. When I removed my intake resonator, it was back on not even a day later😂, made cool noise but also made it feel like half the oomph left the car
if you have a larger intake = and turbo - a K&N filter = you will benefit a little more = + driving the car for 1 hour will see it retune it`s self ! = i did it and yes a little and high RPM - 3hp . = my ej207 rev`s to 8,500 rpm ! so all is a little differant = GOOD LUCK = turbo subaru ! YES .
What were the measurements for the citronella candle lid? Thinking of getting pvc push on cap, they have then in 50mm 90mm and 100mm, could always machine down to size but if you know off-hand could you let me know? I'll be doing this plus muffler delete and let you know how it goes.
Hey Lachlan, okay I still have the candle out on my deck so just gave the candle opening/hole a quick measure. It’s 70mm in size - that’s the opening only and not including the edge. Including the glass container edge it’s approx 87mm. Hope that helps!
I just bought a prl drop in box with air duct came with a cover for the hole to remove the resonator but I cept mine in to keep fresh air. The resonator is made to hole back pressure of clean air in and circulation to keep air pressure built up.ive dyno cars before and they actually lost pressure in the system and dround out the performance.to my eyes it was proven by real numbers .kind of like a exhaust you want back pressure. Not the people that do resonator cat deletes and do straight pipes. You actually kill the car performance
Hello 🙋, I got a question, I removed the air duct, resonator and filter housing for cleaning, I noticed small holes in the resonator and filter housing so I filled them with silicone. What is the purpose of these little holes, and if I seal them would it be a problem? Please, answer me 🙏
