Aluminum Trailer Weld Repair 

Thank you very much for posting this. I have seen a lot of weld failures in aluminum frames for ultra lite RVs. These weld cracks can cause catastrophic failures so it's good to know you are a competent aluminum welder. Folks, it's important to take your repair to someone who UNDERSTANDS how to weld aluminum like this gentleman here! Thank you!

Nice! Solid repair, and thanks for the explanation of why you used crush tubes and bolts….elegant solution!!!

Good analysis on integrating fasteners in a high vibration area like that. Nice work.

This was my first video of yours and I must say you are a impressive young man

Very well done, really liked the work around to Improve the overall design 👍

This man is wise beyond his years

Did the same repair on a similar trailer. Used bolts as well to reinforce and was actually first paying job with PW 225. Customer admitted to not opening the valve when off loading a vehicle.

Wow, amazing job! Great knowledge and work ethic to boot😊

Great job! Another great video as always. 2 questions what did the penatration of the weld look like off the old bracket? From the video it didn't look there was any. 2 did you use the primeweld 225x for welds? Thank you

Nice work again never disappoints seeing what you can do

Your background music is really weird and makes it hard to watch your videos, which are really good by the way.

Great video. Thanks!

Great video. Very nice job, thanks for sharing.

Looks good!

Great job Amigo!

Nice work 👍

If you look at it closely the original bracket actually had kind of bad geometry because it stuck out too far, whether or not it was actually broken from dragging, im sorry but I'm kind of skeptical on that one. It still looks like a really thick bracket attached to a not so thick plate attached to the chassis that was relying on that top bead of weld for all of its strength. It looks like it the hydraulic ram would rip it off. Either way nice job I think the way you repaired it is a whole lot stronger than the original setup. you shortened the bracket and now the stress is on 3 steel bolts, STEEL BOLTS!!! vs one aluminum bead.

Very good and informative video, keep it up!!

I wonder if the manufacturer would even listen if you reached out to them to tell them about the design flaw of their mount dragging

Wait what’s that’s sauce you dipped the flap disc in?

can you do some spool gun content

Johnson wood floor wax ?

What was the purpose of the cylinder on the side frame??

Hey bud, What is that wax you use to keep The aluminum from loading up on your flap disc? Tried pausing the video but you were too quick.. lol.

Doesn’t seem like a weld issue, but either a capacity/design issue.

❤👀👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍

Boop