When something needs to be done on a machine, that is usually what is needed.
It happened this time too. The fly is usually used on a milling machine in a vertical milling head, so I bought a cutter and put it off "until better times." But in preparation for the installation of the VFG, we immediately needed a flyer ... As a result, I made it now and tried to use it together with a horizontal spindle and my USP-12 blocks, a video about this method was here: • Использование фрезерно...
In general, I liked the treatment with the flyer very much. But it turned out that my 550W engine was clearly not enough for her. If you remove about 0.5 mm per pass, then you had to reduce the spindle speed with another gear and spin the motor with a frequency converter raising the frequency to 60 Hz. In normal modes, the engine began to warm up. It is worth bearing this in mind. In this case, the machining diameter was 148mm.
There is also a jamb in this product (not critical), whoever will notice, that is a separate + to karma :)
Details of what exactly I sharpened in this video, in one of the following videos on the channel.
29 окт 2021
