An Ambrogio Twenty Elite S+ navigating a narrow passage 

The wires need to be at least 30cms from each other. If you have a setup where the mower can travel along the same wire to get to an area as it comes back then the other wire can be at the edge of the passage as it will not travel over it. You also need to ensure that the mower won't go down the passage when returning to base i.e. have it traveling away from the wire on the return. You need to turn the border cut off or put a block in place to ensure it does not follow the other wire when it does a border cut.

No, it only goes down the passage when going to/ from an area so the blades are not turning. You just need to ensure that you don't schedule a border cut or block it off so it doesn't go down the passageway when it does a border cut.

@@therobotmower9572 How do you prevent a border cut for that area alone? Or do you have to not use border cut at all?

@@P44man you can either turn off the border cut completely or put a obstacle on the wire just as it is about to go into the passage - it would bump into it and then loop across to the other side of the passage and carry on.

@@therobotmower9572 The passage is >10m long though. Its about 1 meter wide (its a path with raised beds on either side). I worry its going to try mowing there, and go back and forth forever.

@@P44man if the passage is 1m wide then the mower will only go down the passage when it is going to/ returning from an area... you can make sure of this be making the gap between the wires to be 30cm.