Here is the link to the analog signal generator I use in the video: amzn.to/3nNMP4k This video is about Analog Input in RSLogix. I will show how to do basic control from an analog input.
Again, thanks a million times professor, very simple and straight to the point I started to watch your Allen Bradly videos, literally one by one, very informative you really made my day
hello, im integrating a keyence il-1000 sensor on a project. ill be using it to select different motors depending on a length measurement. Which instruction can i use to select each different measurement?
Great question. I am not sure. I have never tried. But I do not believe so. What might work is set up a move instruction to move a value to the needed locations. Does that make sense?
@@KletteTech So I ended up disabling the scl block and using a float file to write to the output of the scale block with a move instruction. That worked. After a few tests and putting everything back how it was, some of the values stay pegged so I had to cycle power through and everything went back to normal.