Annex Engineering K3: Build Part 03 - XY Gantry 

_______________________________________
Music track: Stuck by Aylex
Source: freetouse.com/...
No Copyright Background Music
_______________________________________
NOTE: In this video, I mistakenly transposed the linear rails for X and Y. I didn't realize this until a while later when I went to install the toolhead onto the gantry.
To correct this I simply removed the XY tensioner assemblies that support and hold the XY linear rails in place, and rotate them both 90 degrees.
If you are facing the front of the printer, the crossed linear rail that runs left to right (I will call this the X rail) should sit lower than the rail that runs front to back (call this the Y rail).
Links:
Annex Engineering K3 Gasherbrum:
github.com/Ann...
Fabreeko's Annex K3 Kit:
www.fabreeko.c...
K3 Build Instructions:
github.com/Ann...
Thanks to these Canadian vendors for selling me the required parts that were missing from the Fabreeko kit:
3dhub.ca
3dlabtech.ca
northprint3d.ca
sparta3d.ca