Anycubic Vyper PID Auto Tune Pronterface 

Thanks for your videos. You cover everything! Every time I run into an issue, you appear with a guide 🙏🏻

Thanks for all of your Vyper videos!! Very helpful.

Man it answered lots of questions i had about using proterface

I watch all of your videos and I have learned a lot. I do have a comment those of us that are new into this hobby don’t have an idea of even want a PID tuning is. You would do us a favor if you could explain that before you start a video like this.

After 6 months of working great my Anycubic Vyper started make an alarm sound whenever I started a print and would stop when the bed got to 80 degrees. Followed the PID tuning for the bed and all is fine again, no alarm. Thanks!!

thank you for these videos, they were very helpful!

You Are Great Men !!!

Great video, doing it right now with octoprint.

Thanks for the mention in the beginning, would send 10$ - but that was not able in euros ;-)

Are these settings being saved onto SD card or internal EEPROM chip on the printer? I am having issue with my Vyper loosing bed mesh/estepsnsettings after power cycle (if SD card is not present). I am running community firmware.

Is this auto tune of nozzle so you can ensure you are printing at the temps you think your printing at? I swear my Vyper is printing hotter than what my gcode says to heat to...

If I’m already connected to my printer using OCTO print and raspberry pi, is there any advantage to using Pronter

Does that U1 work on Enders as well?

Contributed

Great video. Please change C5 to C3 in the description due to command M303 E-1 C5 S60 U1. Thanks