Apertura Roll Easy Kit | Review & Assembly | High Point Scientific

Подписаться 29 тыс.

Просмотров 3,7 тыс.

50% 1

The new Apertura Roll Easy Kit is a roller kit for your Dobsonian telescope base, providing your Dob with a built-in caster system. With the caster kit installed, you will be able to easily move your telescope around without needing to lift or disassemble the scope!
This comprehensive kit makes getting out under the night sky a breeze, so you can spend more time observing and less time setting up!
Order your Apertura Roll Easy Kit for Dobsonians here: www.highpointscientific.com/a...
Check out our entire installation guide here:
www.highpointscientific.com/a...
#highpointscientific #apertura #dobsonian #telescope
Chapters
00:00 Introduction
01:08 What Does This Kit Do?
01:53 What's In The Box?
02:20 Prepare For Installation
03:09 How To Install
06:49 Final Result
07:06 Conclusion

Наука

Опубликовано:

10 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 8

@RandomStranger69 16 дней назад

For best results just drill down a little with the bit not to go all the way through. You just need a hole for the screw to start.

@HermaphroGynandro Год назад

I duct-taped a lot of coaster wheels to the bottom of my dobsonian years ago. This would've been nice to have had then!

@Astro_Ape Год назад

Ohh wow, awesome idea!! I like the fact that us amateurs have options other than the current Dob dollies on the market that seem to be well made yet extremely expensive. I probably won't get these for my AD8 since it's not too bad to carry (base & OTA separate) and the added height probably wouldn't work well with the observing chair I use with it, but that AD12 that's in my very near future is definitely get a set!!

@andromedach 10 месяцев назад

I am just curious at stability on inclines and over door thresholds.

@BobGeogeo Год назад

Nice idea but... Won't the weight of the scope tend to pull the plate mounting screws out of the ground board over time?

@highpointscientific Год назад

"Hi! Thanks for the comment and that's a good question! This was designed with that consideration in mind, and subsequently tested by one of our 210lb techs jumping up and down on the assembled base (don't tell OSHA) for a considerable time without any damage to the base or the screw holes! We're confident the weight of the AD8, AD10, and AD12's won't be an issue over time!"

@Astro_Ape Год назад

Nothing like some a good tech to play crash test dummy!!

@Triggerhappypilot 10 месяцев назад

@@highpointscientific perhaps consider some triangular cross-bar to connect the three plates together to prevent them from levering out over time? I could see this being really useful on the heavier 14" and 16" dobs but right now they seem like they might yaw out of the particle board since you'd be creating a lever arm around the edge of the board. if the 3 plates could be bolted together with an adjustable metal centerpiece (to fit different size baseplates), that wouldn't be a concern.