Arcade1Up Pac-man XL mod with Mr Burns vertical image 

I did manage to get it working after a lot of trial and error. Unfortunately, I don't really remember exactly how I got it to work. You have to mess with the Input settings, under Quick Menu - Controls. Set Port 1 and Port 2 both to the same index, if I remember correctly. Then mess around with those settings a bit, you will probably figure it out. When you do, please share what the trick is because I honestly forgot! I wish I'd made a note about it. From a quick look, I have Port1 and Port2 on the same device index (in my case DragonRise USB controller). Port 1 select is Auto 10 (shift in my case), Port 1 Start is Auto 1 (Enter in my case). Port2 Start is Auto 10. Port2 Select is N/A (Off). Let me know if this helps!

I haven't seen the A1up cocktail, but I would bet that it will fit just fine!

Also I should mention it didn't cost me very much more like an extra five or $10 to get legit happ parts it was definitely worth it

If you're just upgrading the stick, I don't think the one in this video will work. However, before this mod, I upgraded the stock stick with one of these, and it was a huge improvement. You can set the gate to be 4 or 8 way (recommend 4-way for Pacman, etc). Also, I recommend you get a stronger spring (4 or 6 lb - I like 6lb, myself): www.diyretroarcade.com/collections/arcade-parts-control-panels/products/genuine-sanwa-jlf-tp-8yt-5-pin-joystick-for-arcade1up

@@TreZ Thank you!!

This image only includes vertical games. However, you CAN do that with a different image, or if you set up your own.

If you're going to mod it, that's really just a question of which one you prefer the look of. XL is harder to take apart and reassemble. But if you're going to mod yours, you'll end up replacing the stick and games, so it's up to you

I have all the machines plugged into a power strip, which is turned on/off with a smart switch.

Sorry, I don't have footage of the P/N number, so I don't remember. You can find it by opening the back of your cabinet - it's right on the monitor itself

@@TreZ Thanks for the reply! I got the monitor P/N off your video, but cannot find a driver/controller board for it, just wondering if you still had it off the one you ordered for your XL, Thx!

@@Bergman1980 Oh I misunderstood your question - just contact DIYRetroArcade with the monitor number and they'll make sure you get the right one!

If I had known that, I would have done it! But, I'm happy with it as it is. I have plans to mod my TRON machine next - I might bug you with some questions about the power/volume switches when I start that project, if you don't mind :)

If you mod it with a pc instead, is there a way to make the power and volume buttons work?

Not that I am aware of… I would think there would be a way to do that, especially for the power switch, but I haven’t seen anyone do it.

I haven't done a PC mod, but I imagine it wouldn't be any more difficult, as long as you are able to set up the emulator to your liking

You are right - I've since disabled Zaxxon for that reason

Really? Thanks for pointing it out! What would you recommend I use instead?

@@TreZ any USB plug you use no matter what it is a cell phone charger 5v dc not 12v dc you need 12vdc for your coin door and the marquee and video driver i have all the 12v dc run off a 12v switching power supply i also deal with DIY know Shane if i was you i would use a 12v switching power supply and use the +5v for your raspberry pi and 12v for everything 12v remember the power supply is Yellow is 12v and Red is 5v that is how jamma is but i know you not using jamma.