Great job, nice to see the inner sleeve left longer than the gland base, too many folk cut it right back and you end up with single layer of insulation next to the rough gland inner. That would pass a Chemical plant inspection if it was an E1FW gland. If you use adaptors, the inner sleeve should go past them by at least 10mm though. I think 3 and 4 look a bit short on the inner sleeve.
First cable too long tbh. I would advise not cutting the inner insulation off until after it's in the isolator. This avoids possible scratching of the core insulation. If you score around the inner insulation first before inserting then the inner comes off easier . Good effort though my friend . Spent over 35 years doing swa btw lol 😆
