Arrma Senton 4s with Rc Madlabz High Performance Chassis Brace Kit 

Thanks bro, its definitely a stout little rig now.

Nice bro, if u haven't herd Jenny's rc has tons of new parts for used prices. Perfect for the build your doing.

Definitely get the metal diff gear and metal input gear/shaft. I have both installed. The plastic gears don't hold up.

Thanks, it's def a beast!

You can get the motor plate and chassis block directly from M2C Racing.

I haven't tried making sway bars. It would be fairly difficult there isn't anywhere to attach it to on the a-arm. I'm sure something could be rigged up but would it even make a difference? I don't know.

All of them.. lol

I'm not sure what you mean by hangs up... Does it flip over? Or shut down?

@@soulrebelrc6341 The arrma senton shutdown is only working again when I press the on and off button. I believe it is overheating, I have an additional cooler, how do I install?

@@fillype91 If it's overheating it won't turn rite back on. It's probably the low voltage cutoff turning the ESC off when your holding the throttle wide open due to a battery issue. I've had this happen to me when I had one cell going bad on a 3s battery. The weak cell can't keep up under load the voltage drops and the ESC kicks off. Either get a new battery or change the low voltage cutoff to a higher voltage. I don't recommend changing the low voltage cutoff.

@@soulrebelrc6341 Before the arrma senton shutdown he became weak with low speed. My battery is new, but it wasn't with all the cells equally balanced.

@@fillype91 if u can get it to shut down again the same way it did before, look at the ESC and count the flashes from the blinking red light and that should tell you why the ESC shut down.

It's a half pound or so may a little lighter.

About 12 ounces