ATEM Switcher Tally Lights Wi-Fi with brand new tech is here! 

Yes most will work for this project

Yes, it’s on Patreon. If you search for Maxelectronics.

@@MaxELECTRONICS Thanks! looking forward to it.. do you also happen to have Pick-and-Place file for automated assembly instead of using stencil?

@carlos33193 unfortunately no, it’s to stop mass manufacturing.

Hi, you can only get it on Patreon, could you tell me your username and I will check why you can’t get access to the file.

@@MaxELECTRONICS joaquinpe

Max, I'm trying to replay with my email, that is the user in Patreon but RU-vid for some reason, doesn't let me do that

@JoaquinPerez-li9ep what is your name on Patreon, not user name , I’ve checked, all the files are there

@JoaquinPerez-li9ep are you a paid member on there or free?

also light never changes state from blue. I am using ESP32-WROOM-32

Could it be faulty esp32? I’ve tried on few different models and didn’t have any problems with esp 32. What programmer are you using?

@CTRONICS Looks like the schematic is wrong for R13 an R14. the values are listed as 15k and 2.2k, but per the datasheet of the MT3608 this would be ~4.7v output and this is what i am seeing. Vout = vRef * (1+ (r1/r2)). = 0.6 * 1 + (15k/2.2k) = 4.69.. we need 6v out so I think better values would be 15k and 1.6k ohm resistors. Also the reset RC circuit between EN and IO0 seems to be incorrect. Both EN and IO0 should be pulled high? Can you confirm?

@carlos33193 the resistors r13,r14 are correct. But the R5 is actually connected to 3.3v in blueprints. Not ground. It’s just a schematic error, I can confirm that in gerber files R5 connected between GPIO0 and 3.3v

@carlos33193 both EN and GPIO0 pulled high