ATS panel wiring / Automatic Changeover Switch for Generator / Automatic Transfer Switch 

#ATS_panel_wiring is explained here with fine animation work.
An #automatic_transfer_switch (#automatic_changeover_switch) transfers power supply from its main source to a backup generator automatically, when it senses partly failure or a total failure in the primary source.
When a failure occurs in the primary power system, the #ATS invokes the backup source, which is a three phase diesel powered generator here, to run electric equipment until utility power is restored.
#ATS_panel needs to be properly designed and wired to the primary and backup power sources correctly.
If this video is useful, please subscribe to the channel.
Thank you.
More videos for you 👇
Surge Protection Device (SPD): Operation and Installation on a Single phase or 3phase DB, explained.
• Surge Protection Devic...
Safety Relay: Operation and installation explained.
• Working principle of S...
Automatic Start-Stop of generator with ATS / Automatic transfer switch / Automatic changeover switch
• How to design an ATS f...
Phase Failure Relay (PFR): Operation and Installation.
• Phase Failure Relay (P...
Emergency Stop Push button switch - Operation and Wiring Explained.
• Emergency stop push bu...
Single phase Induction Motor operation with Start Run Capacitors.
• Single phase Induction...
Star Delta Starter Power circuit wiring for 3Phase Induction Motor- Operation explained.
• Star Delta Starter pow...
VFD (Variable Frequency Drive) and Inverter Operation Explained.
• How Variable Frequency...
3 Phase Electricity operation: How it works and Power Calculations.
• What is 3 Phase Electr...
Motor speed (RPM) calculation: Synchronous speed & Fractional slip explained.
• Single phase Induction...