Please explain briefly. Please tell me how did u connect led straw with the wires. In the description also u didn't say the materials required completely. Nice but explain step by step properly.
Bro I have doubt can I ask,all led [Street light are connected in series or parallel connection] tell me also you are connect led that is called light emitting diode are connected in series or parallel connection.😅
Hey I didn't get one thing that there are 4 wires outside ok. But ... You took 4 wires from inside 3 should come out why 4,the forth one is attached with led and batteries as led is out side ??? How you took the led wire (green I think ) from inside please explain
You need battery to power the street lights as the LDR just a sensor LDR is a Photo resistors, also known as "light" dependent resistors (LDR), are "light" sensitive devices most often used to indicate the presence or absence of light, or to measure the light intensity Their resistance decreases as the light intensity increases: in the dark and at low light levels, the resistance of an LDR is high and little current can flow through it - LDR must be put inside the box so it can detect its sensor, when you take out the top piece cardboard, it will stop completely because LDR can't sense dark near them If you put back the top piece cardboard to the box back, LDR will senses darkness inside the box and activate a signal to the battery Then, the battery will give signal from LDR to the street lights wires that attached to the battery and also to the LDR from outside to switch "on" the lights While the other street lights will "lights" too because if you see the video the wires of the street lights near the battery also attached to the other street lights wires
What is the thing you soaked in the salty water in your FREE ENERGY ELECTRIC GENERATOR's charging video? The comments are turned off there so here i am asking .
Nice tutorial..मैं भी यहाँ से सीख कर अपना project बनाया हूँ ru-vid.com/video/%D0%B2%D0%B8%D0%B4%D0%B5%D0%BE-3yDPdK0GpCA.html ..bhai please ऐसे ही और vedio banavo ..
Bro it is very simple. An ldr stands for light dependent resistor. So basically it is a light sensitive photo cell. Whenever intensity of light changes its resistances changes and thus lights the bulb. Whenever there will be darkness it will illuminate.When we place the cardboard, darkness occurs and it gets illuminated.
This project is very interesting. I've liked this project, but some queries connection of the street please explain I'm not understand this connection.
don't try this this Is fake video a areng all thi today is my project submition it is not working😡😡😡... see video demo me bettry se 3video join karr rahe he and reall me only 2.
My circuit is working but ldr system is not working. Bulb lights up when I connect the battery. I have used 547A transistor as I could not find the above mentioned. And please tell me if we have collectively make 1k resistor or resistor should be 1k each? Please reply