They look alot like MIP driveshafts or Incision. Should do well under power and last a long time. The best thing I've found to keep the speaking away is WD-40 gel lube spray. I also use it on my cv joints. Repells dirt/dust and doesn't sling completely off at higher rpm. Great video today.
I recommend getting the 550 can Traxxas Maxx motor. Its 2400kv and way better then the stock motor for run time, Temps, and power. All you have to do is notch the plastic wire guard to get it to fit. Have a buddy with your exact same setup but uses that motor mod and it will flip great. I'd give it a shot man, its impressive. The blx130 has proven to be a tank, but the stock motor gets hot with all the extra weight. We tend to stay tin the 130 range with the Traxxas motor.
The ryfy is a all around vehicle seems a very fun fun rig...i just dropped the Lazernut jumping jumping sky high all stock still...# Lazernut on V&B speed ✌👋🇺🇸🌏🌏Cream of the crop
Dang. Them. Jumps landed tough. How do you get it to drive so straight. Is all the vitavon upgrades. How much you got in parts not including time into this rig
nice! just bought traeal aluminum axle housings for mine(sorry) a little cheaper. will see if they are as strong. your ryft is bad ass.i think i will do the vitiavon drive lines and trailing arms and links though.i got those same rims for mine from your link.
Treal has some nice stuff and I’m Sure they would take this. I’ve seen somewhere someone bent another brand arm. Well I don’t think they were Vitavon because these didn’t bend. LoL.
I keep loosing u joint pins so now I bought the vitavon driveshafts....Is it just me or does the weight of the heavier drive shaft carry momentum longer after you let off the throttle? It seems like I have to let off the throttle sooner launching up hills. I have two Ryfts (less then 6months old) that both also have loose u joint pins in the axle shafts....I can't find anything anywhere about how to fix or avoid this problem. They chewed into the plastic knuckle and I'm only lucky I haven't lost them. If anyone has any helpful comments relating I'd very much appreciate it.
My problem with Vitavon product is for each axle housing you could buy a new RC for each link setup you've bought half a new RC. I understand it can cost a lot to upgrade an RC but at what point is $3-500 per upgrade just too much? It's getting to the point where it's killing part of the fun of the hobby, upgrading. Appreciate your content but you've become a Vitavon representative or are you only representing high end stuff because the rest is not worth your time? I can see why you need so many patreons.
