Axidraw 

hi it's hiwin rails and bearing, 9mm

you prolly dont care but if you guys are stoned like me atm then you can stream all the latest movies and series on InstaFlixxer. Been binge watching with my brother for the last couple of days :)

@Anthony Lionel Yea, have been using instaflixxer for months myself =)

@Anthony Lionel Definitely, been watching on instaflixxer for months myself :D

@Anthony Lionel yup, have been watching on instaflixxer for years myself =)

Its called TSP. Infos here: en.m.wikipedia.org/wiki/Travelling_salesman_problem And a nice software plus explanations in how to generate points and then connect them using TSP here: wiki.evilmadscientist.com/StippleGen

Seconding this!

Get 2xnema 17 stepper motors, and Arduino with cnc shield. Then get 2x aluminium profiles that are 20x20mm. In whatever length you want, and 2x linear rails with the same length. The model of linear rails are probably mgn 12h. You also need 4x limit switches, M3 or M4 steel screws that matches the mgn 12 rails, and T-slot nuts that matches the screws. Also a 24v power supply, that can handle about 3-5amps(depends on how much the stepper motors need)

You also need an aluminium profile connector set. And a small servo motor for lifting the pen up an down.

@@GoalOrientedLifting I have the aluminum profiles

@@boharihamen I also almost forgot, you need belts that goes the whole length of the travel distance, and back, for both axis. And 2x gears for the belt, on each axis. As that's what the stepper motors use to make them work

I need this too

look for TSP line art

By Amazon

It cost about 1500

Malek0096170416235 Saih I just bought one. It’s arriving today. eBay had a 20% off everything with the exception of coins and currency. You should wait and see for another deal like that. I couldn’t help myself. I might be able to pay it off eventually which would be great.

1000 to 1599

1499 not 1599

@@javediqbaldar7 no it cost much higher

Hi, no time for the moment but later, perhaps I can make something, I have to change some parts and probably the system of X Y cause the firmware for the axidraw need the two motors on the same transmition, so with my mechanical system I have to rotate the drawing 45° it's not useful, Stay tuned, probably in september I will make something and try to put plan and tuto somewhere.

But that's frankly somewhat more incredible, if this can be achieved with skewed axes.

How did you solve this problem? I'm with the same problem, and i didn't understand that "two motors on the same transmition". Could you help me? If you know it, of course. Thanks

@@marciogustavo6204 the difference is this uses 2 belts , and not 1, like axidraw (T Style) .

1000 to 1499