Axle Pull Install From Enduro Engineering 

I use a rubber mallet and heres how it works... With your bike on the stand and front wheel slightly elevated loosen the axle nut and loosen the lower fork leg clamp bolts. The axle nut should still be on the axle about 2 turns in. If you keep your axle clean and greased it will always be easy to remove. Next push the axle with nut on as far as it will go(do not hit the nut with the hammer as you might jack up the threads), now take the axle nut all the way off. Now take the rubber mallet and tap the lower fork leg on the opposite side of the axle with threads, this would be the front right leg while sitting on the bike. The axle will work its way out!! I do this every time and it works great. Keep that axle clean with either a wire wheel on a bench grinder or on a drill with a wire wheel, 0000 steel wool and simple green work great if you dont have the power tools. Apply a nice thin coat of grease(belray tub of grease is awesome) so next time the removal will be super easy. Dont forget to like and subscribe on my comment😂😂😂✌ Hopefully this helps some of yall. If you dont grease your axle and keep it clean this might not work for you.

With the handle installed, when you remove the axle you can now hang it from the foot peg or brake pedal and keep it out of the dirt, it helps keep it clean if your out on the trail.

I'm not a clark... Great job, you covered everything!

Thank you. One axle pull just got fitted to my 2021 KTM350EXC.

Who said you can't get a good haircut at the barber college? Thanks for recording right after the lunch buffet. Dorothy say's hi!!

KDX's had that from the factory 0ver 35 years ago,LOL.Ride safe my 2 wheel friends.

Awesome stuff. Great job

Dirt Bike TV - what about 2022 new bikes can't be ridden off-road in California?

Holy scrubbin bubbles

Great job

In the front axle there is a 10 bolt If we don’t put it back there is a problem??

The Enduro Engineering install video shows the handle being positioned to the rear not the front. Not sure that it really matters....Will this work with lower fork guards? Do you recommend the rear pull as well?

What are all the green aerosol cans on the floor behind you?

heygoodjob

It looks like he installed the rear axle pull in the front axle.