Bad CV Axle In Your Car  

I have footage on the CV axle replacement on a Nissan but my cameraman was so shaky I felt like the viewers might get nauseas if ai post it.

Right on! Thanks for your comment.

Grease sl8nging prevents rust. 😜

Sometimes they come out easy, other times they don't. Depends usually on the design.

That's for sure. Thanks for stopping by.

@@ozzstars_cars Oh I always stop by to see what you’re up to when you post a video!!

Good eye! 👀

Sometimes the hole can be a small slit between the cv boot ribs. I have also seen grease get out from a slightly loose boot clamp. Even a pin hole can spring a leak.

Hi Steve, hope all is well. I'm still breathing. haha

@Ozzstar's Cars You have been on vacation I figure or a mid life crisis 😅😅

I might get some PR40 just to play with. How do you stuff new greae into a cv boot without removing the boot to do it?

@@ozzstars_cars Well if there's a rip or a hole just pack it in there with your finger or shove a grease gun in the rip/ hole, etc... Otherwise, you can get a needle for your grease gun and use it to slip behind seals and even sealed bearings-- and you can just puncture the rubber and add grease that way (if there is no hole or rip). Then you just drip some pr40 on it, and it reseals the little puncture. I don't particularly maintain my stuff well enough to bother with these little tricks, but I've helped my buddies do it on their cars in a pinch. lol.. I'm kinda the same with my rifles. I dont' bother cleaning them usually-- and just run them until the barrels are junk, because I can easily swap out another nitride AR barrel for $60; so why bother babying it..

@@calholli now that you mentioned it I bought a grease gun needle a few years back. Now I just have to find where I put it. lol

I had the open turkey for lunch which was edible but the apple pie was terrible! 😜

Good question Will. As soon as a sick bike comes in to be repaired. 👍

Back at ya. 👍