ROKADE Induction Heater Series are intended to perform heating of bearings, half-couplings, gearwheels and metal rings for their interference fit on a shaft. The heating process is controlled automatically by a temperature sensor, which is installed on the inner bearing ring.
The induction heaters automatically demagnetize bearings (parts) after heating to a defined temperature. The heating can be conducted based on the temperature control or time control. These Induction Heaters are available in various capacity, by means of bore size of shaft Bearing, weight of Bearing or Pinion or Gear or any other component to be mounted on shaft, Time of heating periphery of inner races of Bearing etc.. All the induction heaters are delivered with thermal-resistant gloves and yokes.
MODELS →
RIH - 1000
RIH - 1001
RIH - 1002
RIH - 1003
For enquiries! →
sales@rokadegroup.com | 022 - 2173 7777 | www.rokadegroup.com
Subscribe to our channel now! →
ru-vid.com...
Join us online! →
/ rokade-group-of-companies
/ rokadegroup
/ rokadegroup
ROKADE HI-1000 is a small-size, lightweight, high-performance and cost-effective induction heater with an electronic control. The induction heating can be conducted horizontally. The heater has the function of automatic demagnetization of bearings upon reaching a defined temperature. The induction heater is intended to heat parts weighing 25-40 kg with a maximum outer diameter 300 mm.
The induction heater ROKADE HI-1001 is intended to heat bearings and parts weighing up to 105 kg. The induction heater has a heating temperature range 0-250°C. The rotatable yoke is easily input to the bearing hole. This has an electronic timer from 0 to 99minutes for setting the heating time. The heater has the function of automatic protection from overheating and function of automatic demagnetization. It weighs 42 kg and is intended to heat parts with a maximum outer diameter of 400 mm.
Where parts are to be heated before installation ROKADE HI-1002 can be used. Heating of bearing replacement, coupling installation and heating of gearwheels before gearbox assembling can be done. Fast, easy and cost-effective heating of any part before installation can be conducted.
Bearing heating, coupling heating and installation, gearbox assembling is performed several times faster in comparison with traditional methods (hot plates, oil bath, burners, etc). Heating of parts weighing up to 125 kg with an inner diameter up to 20 mm can be conducted by using ROKADE HI-1002.This also has an electronic timer from 0 to 99 minutes. 6 kVA is the maximum power.
ROKADE HI-1003 can be used for installation of gear drives and replacement of large bearings, rings and couplings resulting in qualitative assembling and dismantling of bearings and gear drives. This instrument weighs 75 kg and can be used to heat large sized bearings of up to 300 kg with a minimum inner diameter of 60 mm and maximum outer diameter of 650mm.
13 янв 2021
