Awesome video, super helpful! I just finished the wheel bearing replacement. I found that using a pair of vice grips and hammering that was enough to pull the cv axle shaft to catch the threads.
It is some kind of a random clamp I got it from Ebay and I showed part # in the video. But in reality, later on I found out that there is a special axle puller tool set instead of hammering it back ad it cost like 50$ on Ebay , so you should get it instead of that type of a clamp and hammering... Next week I will be replacing rear bearing and I will be using that dedicated axle pulling set that I purchased for myself, as I dont want to hammer it again
It's a little tough to see, but I'm pretty sure those aren't hex heads. Those are torques T25 Something like that size. Because T5 those are tiny tiny . They sometimes call the bit a star drive.
