Didn't work for me. I had the brake pads and rotors and wear sensors and changed the brake fluid on all 4 wheels. Parking brakes work fine. Everything went well as expected. A week later I forgot to reset everything. I was able to reset all parameters except for the rear brakes. Now I keep getting a dashboard warning light to check my brakes. I even changed the rear brake pad sensor 3 times with new ones. My parking brakes were off at the time. I drive a 2011 X3 28idrive
Follow the steps listed below in order to Reset. 1- Make sure to turn off your car with the emergency brake off. 2- Take the driver side wheel off. 3- Follow sensor cable from the brake caliper to the black box, open and unplug the sensor gently. 4- Plug the sensor back on and close the box. 5- Keep your foot off the brake paddle, Press on the ignition bottom one time, press and hold the service bottom until you see the service menu come up. Select front brakes, Release press and hold the bottom, reset possible? Release press and hold the bottom to perform the reset. Note: Sensors are not necessary to replace unless is broken, defective or faulty.
Follow the steps listed below in order to Reset. 1- Turn off your car and keep the emergency brake off. Secure your car tires from moving! 2- Take the driver side wheel off. 3- Follow the sensor cable from the brake caliper to the black box, open and unplug the sensor gently. 4- Insert a Paper Clip or a Staple into the small holes, sensor part going back to the car. U shape the Paper Clip or Staple to create a bridge so you have an unbroken connection. 5- Press the start button one time, Keep your foot off the brake paddle, and the emergency brake off. Press and hold the service bottom until you see the service menu come up. Select front brakes, Release press and hold the bottom, Reset possible? Release, press and hold the bottom to perform the reset. .Reset Successfully completed! Note: Sensors are not necessary to replace unless is broken, defective or faulty.