BMW water pump bench test. E60

Подписаться 112

Просмотров 2,3 тыс.

50% 1

If you've gone through the process of checking your fuses and want to know if your water pump is bad, try this.
This will tell you if you have a wiring/power issue or a bad water pump.
If you can access your plug while it's in the car you can test it without removing g the pump. Just unplug it and test it mounted in the car.

Опубликовано:

28 ноя 2023

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 3

@erickbonilla4023 2 месяца назад

Nice video i have a issue with my beemer 535i 2013 this is the 3rd water pump i buyeed and still not reading the computers still giving me over hit and said error water pump still missing

@Hives2honeyfarm 4 месяца назад

Nice video. I just pulled a bad pump out my daughter's car. I checked the harness for voltage before pulling. Wires were sending volts at correct times. After I pulled it, I bench tested it to see if I could at least get something out of it. It's dead. I'm going to do a quick test on the new one before I install it, to make sure it works. I ordered a cheap one off Amazon and all the RU-vidrs say, it won't last. But,for less than half the cost I have to find out for myself.

@dreamstasis5672 2 месяца назад

From my research be sure to replace the u shaped hose between w/pump/Themo that hose shrinks and swells with the heat from block causing coolant to flow top of housing eventual contracting cover till cracking or the sealant gives between cover and unit. I suspect the rvt sealeant used is crap. but to open a unit and waterproof micro controller board and put Honda rvt on unit should last a bit longer lol Even on eBay units. Cause they all fail due to water intrusion......