Come along on this DIY project and experience all of the thrills of boat ownership. In this tutorial I will take you through the entire process step by step.
Going to be doing this to my Pursuit 2870 in the next few weeks. What did you use for the joint seal material? I have used 3m 4200 in the past but it turned black in less than a year. Topside still has some original sealant that is as white as the day it left the factory in 1999! Did you lay the tank in the bilge without any type of support or barrier? Have seen other videos where rubber was payed down. Any thoughts on this? Thanks for the video!
I’ve always used silicone for the deck seal and it has worked well for me. As far as the supports…..yes, there are pads located under the tanks that provide spacing and allow the foam to flow under and around the tanks. Good luck with your project!
Interesting very interesting. Thanks for the information. What is the product you needed to remove that surrounded the old tanks?oops i guess it was unfinished (yellowish) fiberglass