Bosch Angle Grinder GWS 6-115 - Bevel Gear Replacement 

Great way to destroy your axle(just like you did :P). If you have bearing separator AND bearing puller then just simply hook puler to the separator. If you have only separator just clamp it like you did and then use 2 screws, and ~10mm steel bar to push the axle. Separator have 2 vertical holes, one on each side - use as large screws as possible. You need to drill 2 holes in steel bar in correct distance to push that axle. If you don't have separator / puller you can use long socket and hammer, but please use at least copper coin on top of axle to not destroy it like on this video.

Muchas gracias por el video es de gran ayuda Dios lo vendiga

many thanks for your help. now I can repair mine with same problem. thank you so much- renato Italy

Ok! Muito bom mesmo! Valeu 👍👍

Thanks so much it worked 👍🏾

the gear housing, can fix other brand ?

Thanks Man!

Техника ,на высоком уровне разборки ушм блогадарю, учус.

Ótimo trabalho parabéns 👍👍

Was it expensive for the parts and the necessary tool. I’m guessing it would be the same to get a new one maybe?

Super Job , ich hab ein PWS 620 , das was Sie repariert haben , ich meine die Kugellager ist defekt die mit Getribe (abstands metal ist kaputt und die kugellagern die bleiben alle zusammen .

Destruido el eje por los golpes, bruto... tendrías que usar un punzón o un extractor de ganchos.

can use any type of greese oil ?

golpear directamente el eje para que salga no es algo tecnico, ya que deforma la punta del eje, si se cambia la corona se debe cambiar el rodamiento

You need to put a little more grease

Where you got this gear

।। 🎉ট।😊

wrong fitting