Brake Flush, how to Flush your Brake system Honda Element 

The order you bled is not the order that Honda recommends. You need to go driver front, passenger front, passenger rear, and then driver rear. Just look at the Honda service manual. You should also angle the tube up so that when you are pumping the fluid, any air that is trapped in the system will also be cleared and you can see that in the tubing as the air bubbles will rise up towards the top of the arch of the tube. Lastly, you should make it clear to your viewers that there's no set number of pumps that you need to do to clear the fluid. You just pump until you see clean fluid and no more air coming out. Making sure to check the reservoir every few pumps to make sure it doesn't run dry.

Danny your videos are incredible. Thank you for all the time you put into this channel to help people out!

really enjoy your videos, very informative and easy to follow for newbies.

Very informative video. Thank you Danny! Just one question - did you empty the jar between wheels? It doesn't look like it fills up very much as you go through this process.

Thanks. Was looking for info on bleeding without taking off the tires. Clean garage 👌

Another great video Danny. Thanks so much. Just what I needed

Very nice tutorial. Thank you sir!

Thank You for your Videos throughout the Year .....Greatly Appreciated .... Have a Great New Year ...

Grate video. The flushing brake fluid is same for an 05 Honda element too?

EXCELLENT VIDEO! THANKS!!!

perfect

Question how do you know there is no air bubbles. After you close the bleeder screw

Have you considered just using speed bleeders? One way/check valve. Air goes out but can't go back in. And no assistant needed.

Danny, I'm going to do your procedure for the brake bleed process, Question: Can this job be done without removing the tires??? I have a 2010 Accord. Thanks,

I can’t get the fluid to come out all that comes out is air bubbles please help me

Hi Danny, could you link or let us know where you got that specific tube you're using? Thanks amd great video 🤠

Danny, I am half way done but used way too much tubing. It spirals before reaching the container and I see the old brake fluid is getting stuck in there, with gaps between the fluid and the jar. Is there a risk that this could introduce air bubbles into the line?

Perfect

Dies your car need to be in the accessory mode or completely off??

What a great video. Thank you. Do you know if is the same way ( start with back right tire etc ) on 2015 civic? Thx

How much brake fluid did you end up bleeding out?

Is the tube outside diameter 7/16 or inside diameter 7/16?