Hello nilesh bhai..Fark pada but bohat jyada nahi.. brezza ka main engine noise dash area se andar aata hai and woh karana bada kaam hai.. you can skip hood if budget constraints else woh 1-1.5 sheet mein ho jayega..
@@Akash-ij8kw you can definitely go for it however do check for any wiring issue or old/torned rubber covered wirings before they start sticking the dampening sheets bcoz once sticked its v v difficult to take it out for any repair work later on… thats the only negative otherwise all good and you will definitely feel the difference in noise levels of outside vehicles.. however with brezza most of its engine noise comes through dashboard area so you wont feel much difference there if you dont go for damping there too(not recommended as it will be v expensive and while dashboard has to be reassembled).. However overall noise levels from outside and passing vehicles etc will reduce significantly. Go for doors, boot & hood only.. if you have more budget then lower body. Good luck.
Hi Rupesh, damping so far is all good, noise level from sides got reduced significantly however if you expecting lesser engine rattling noise or tyre noise then it wont make much difference as that requires damping on floor and behind dash area too. Overall noise level inside cabin gets reduced by 70-75% if just do doors and boot like I did. One suggestion go for single layer damping in boot as double layer will increase weight and your struts might not take load, I replaced mine and now its all good. I assume you looking for damping only and not HID lamps. Feel free to ask further Q’s if any.
@@thetravelmatic Thank you for replying, brother. I went ahead with damping for all 5 doors as of now. Since my car is new boot lid didn't cause problem. I will remove one layer if required in the future. I also got the LEDs(DHP brand - 55w) installed for both projectors and reflectors, replaced all yellow bulbs from my car to white(cabin and parking light).
Update : dikki ke gas struts change karaye and now sab thik hai. Purane wale weak hogaye they isliye bhi problem aa raha tha. Gabreal ke new dale khud hi mangwa ke.
@@idashcam8532 if I remember it was either 11 or 12… covering all 4 doors, hood and Boot.. i think cost wasn’t 10-11k it was somewhere between 9-10k.. exactly yaad nahi its been sometime now.. per sheet was approx 800-850
Vijendra aapka question is video se relevant nahi hai but jitna mujhe pata hai mein aapko bata deta hu.. Lxi mein officially toh NO, seat mein rods jane ka provision hi nahi hai.. kuch Accesories wale jugad karke weld krke pipe lagate hai seat par and then headrest kharid ke usmey lagate hai but woh recommend nahi hai.. in short lxi mein not possible with existing seat.