Y’all missing the point. Act as if the precut bolt isn’t and it just so happened to snap on you. Then proceed. You people are impossible. Great vid bro.
There is no way a bolt that size snaps, but that tiny bolt extractor could break through the rust. The bolt extractor shaft is a fraction of the diameter of the bolt. A proper extractor would be near the same diameter of the bolt to even have a chance of breaking that bolt free. This bolt was definitely cut or weakened to get it to shear so easily.
Look close they took to a bandsaw like a haking saw it leaving lines of cutting they cut between the threads on each side enough to snap it that's why they took the flap wheel to clean it a bit smooth off imperfect surface so they could drill it if this were real it probably shear with a point that's how most of mine shear with a point like breaking a drill bit point is this is fake no fire no oil
phải nói rằng mũi khoan này bạn rất khó khăn khi thực hiện lấy ốc ra khỏi bàn ghế bạn cần phải dùng sức mạnh vừa phải biết cách làm nếu không loay hoay mãi mà vẫn chưa song đâu nhé,😊😊
@@toolsforworkif you shear off a bolt head that size 7/8 ish you would need 1000’s of lbs of torque to remove it, that little extractor used with an adjustable wrench wouldn’t work at all 😂
@@michaelpurcell2103depends on why the bolt broke, what's been done prior. I've had bolts that snapped because they are so old and rusted, but weren't actually stuck, and had to back out the rest of the bolt with an extractor.
@toolsforwork don't know. Just recently. Bolt broke tap a spot for my bit. Drill a pilot hole, extracter just spins. Yes I'm going in the right direction