I was just about to say that but mine was going to be imagined he didn’t had the time to build a table easy plywood 12 2x4 that’s if you wanna be fancy
Bro if you want to remove welding marks, just buy a 20mm or 10mm carbon road if it's hard to get then cut 15cm burn at the end of 10cm until the resin from the carbon fiber is gone then connect with three positive mice on the body and negative on the carbon brush then make water + salt + citric acid, water 50ml salt 30gram, citric acid 20g stir until smooth then let stand and move to another container because not all salt can dissolve, then dip the carbon brush into the acid salt water then set it to 200a and remove your welding stains quickly and easily.
I know it's petty, but my being a perfectionist would have the wobble in the sticks completely bugging me since they are a very easy job to make rotate smoothly
The only person who always has all the parts required for a project. If asked to build a building, he would already have the tons of material in his backyard required to build. 🤣
@@RICKY-RIKON the speed is determined by the gear ratio, or you can calculate how long it will take to make a complete revolution. ideally, a full rotation should occur in 3-4 seconds