@Dogs Eat Poop I also know it. I asked to place rubber pad so that water doesn't enter the 3D printed pump case. And make the total thing water tight...
No way, brother) the video clearly shows how from under the right hand the author flies out splitting into two - a jet of water ... it is just the water passing through the engine block. I was also tormented by this question.
Nice video, but it literally submerges the motor. Water is clearly seen jetting out from the motor's air vents, as you try to block it with your right hand
Can you use it to control 4 different intakes/outputs, so it's able to fill and empty them in a specific order? Connected parallel or whatever and to be fully programmable. I know nothing about this, but there's a little project I have in mind and I'm trying to gather as much information before I get to it. Thanks
a while back you made your own that was just PVC and some sheet metal. to see that your homemade is as good as 3D printing is amazing. keep up the good work and God bless
Now you're cookin' ! Your original little pump definitely showed promise ! I totally believe this little pump will have commercial appeal ! Maybe if only just the already printed ( limited production ) pieces you have created here ! I am paralyzed from my neck down, and would be totally on board with buying the prototype pieces from you ! ( if affordable of course )
