WHERE TO BUY: acscomposite.com/products/c7-...
How to install Stage 2 Wickers on C7 Corvette 2014+ Stingray Z51s
00:00 C7 Walkaround
4:20 Stage 2 Wicker Intro
6:30 Installation starts
7:17 Remove ACS Five1 Wickers (if applicable)
8:50 Clean surface
9:45 Mask spoiler surface
10:10 Trial fit wickers
11:00 Stage 3 Bridge discussion
12:35 Position template
12:50 Mark holes
13:15 Drill pilot holes (1/8" drill bit)
14:11 Drill nominal hole (3/8" drill bit)
14:50 Remove masking tape
16:00 Riv nut installation
17:10 Hand tighten screws
18:20 Drill pilot holes in two remaining holes
19:40 Optional: Enlarge wicker holes
21:00 Loosely tighten all screws
21:15 Peel 2-way tape
21:40 Torque the screws completely
22:00 End-cap installation
23:10 Apply masking tape to the end-cap
24:26 Mark hole for end-cap
25:36 Install rivnut in end-cap
26:15 Thread screw and tighten
27:50 Stage 3 installation (wicker bridge)
WHERE TO BUY: acscomposite.com/products/c7-...
The ACS Stage 2 Wicker System for the 2014+ C7 Corvette Stingray is a true replica of the OEM Z06 Stage 2 Wickers.
The C7 Stingray S2 Wickers bolt right onto the OEM Z51 Spoiler, and are perfectly aligned with the rear fascia of your Stingray. No misaligned edges, gaps, or rubbing.
Unlike other aftermarket designs which simply take measurements from the OEM Z06 Wickers, and force them onto the Stingray, we redesigned the wickers to match the data of the 2014+ C7 Stingray for a fit that resembles OEM.
Its curvature, its mounting and design will match the Z51 spoiler, and the height and downforce equals that of the C7 Z06/Z07 package. You can add the center bridge, which will convert your spoiler into the Stage 3 Spoiler giving it the true representation of the Z07 package available to C7 Z06s & Grand Sports.
Materials
Our engineered parts are manufactured in plastic injection using a formulation developed by ACS called PC Composite. The blend of plastic enables 3x stronger parts, and high temperature resistance.
Each Wicker is coated in a Carbon Flash Metallic Black finish through our automated paint line, which yields a perfect match to the OEM CFZ found throughout your C7 Stingray including Z51 spoilerbase, rear diffuser panel, grill, fender inserts and more
How it installs
A series of rivnuts will be installed in your Z51 spoiler, which will then accept the Stage 2 Wickers. No rear bumper removal required. See Installation Tab below for the full installation video walkthrough.
What is included?
Driver + Passenger Side Wicker
2x End-caps
Eight Riv nuts
Eight M6 screws
Instructions
Requirements
2014-2019 C7 Corvette Stingray
OEM Z51 Spoiler
Riv nut tool
31 июл 2024