More episodes please. We have multiple Doosan machines in our shop and these make a great reference for our machinists. Your competitors (Haas, Mazak, etc.) do a greeat job of making videos available, you are missing an opportunity to build goodwill with your customers.
Need to make more videos like Haas does. Might also help to have someone in the videos that know what they are doing, the indicated tip was almost perpendicular to the probe.
Maybe, or maybe some needs to get you some education on how to use an indicator* (and spell check). Perhaps maybe you can't see how he has the indicator on the stylus?
Hello ; we have doosan DNM 650 when i start my tool length setting with tsr 27 renishaw GUI i have an alarm (1298 conv inch/metric illigal ) thank you if any help.
The routines in the very first part of the calibration cycle figure out the center of the ring gauge and you have given it the diameter of the ring gauge in the calibration cycle page before you started, so there is no need to indicate it in. Good question though. I apologize for just now answering it, but hopefully this answer helps someone else down the road.
A little late to say this, but most probes don't reach the table. My probe stops about .625" above the table before the soft limit switch is triggered. (More for future readers who see this comment.)
