Can-Am Commander 1000 Belt replace

Подписаться 17 тыс.

Просмотров 29 тыс.

50% 1

In the process of replacing the belt on my Side By Side, of course I ran into issues. With a little ingenuity and the right tools it was not a hard process to correct.
www.Grypmat.com Trio Pack
www.grypmat.co..., use code flashperformance10
or go to www.grypmat.co...
Stainless Steel Thread Repair Kit, amzn.to/39yd5J3
M10 All Thread, amzn.to/2Sqj8ts
Dead_Reckoning_Sting, RU-vid Audio Library

Опубликовано:

7 сен 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 12

@mcohn16 3 года назад

Super helpful, took the mystery right out of the CVT. Really appreciate you showing how everything goes together as well as your creative solutions. I’ll store that little nugget for later when I inevitably break mine 😂

@TrzCharlie Год назад

Excellent video with excellent commentary. Your effort is appreciated. Thanks

@isalmankhan1 4 года назад

Man this was something new for me, Thanks for sharing Bro👍

@traviswester2500 8 месяцев назад

Damn thought I was listening to the Goat.. Mark Dice

@jhackme 4 года назад

We`ll you did a good job > Remember you should have put three bolt`s and evenly removed the outer CVT pully face one bolt I knew you were going to strip out the holes but you recovered well best regard`s Cousin Vinny IE >>>AKA jhackme iam out ..................

@keithbennett1359 3 года назад

Never seen such difficulty changing theses belts , the jack bolt is there to take the spring tension off the belt enough so you can roll it off , there is little to no resistance to do this , can't see how it could get stripped unless you bottomed things out and over forced it. As for putting the secondary back on I never had to use anything other than hand force.

@FlashPerformance 3 года назад

I agree, should have been a simple process. I think what happened was the guy before me used a power tool to run the bolts in and didn't stop and that made a ramp out of the pad and stripped the threads out. Sometimes it doesn't work out like we thought it should. Thanks for watching

@keithbennett1359 3 года назад

sounds like what happened , normally only one of three holes are threaded , the other two are for the holding tool