Carbon Sidekick Series from RLS Exhaust my best Ryker exhaust

Подписаться 2,4 тыс.

Просмотров 1,2 тыс.

50% 1

Whats new for 2024 this is my New Carbon Sidekick series .This exhaust has 2 removeable baffles give you a larger range of sound. this pipe has a deep throaty sound a low growl .find it at rlsexhaust.com link below
Carbon sidekick series link : www.rlsexhaust.com/products/2...

Авто/Мото

Опубликовано:

30 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 16

@deeblues1 4 месяца назад

I'm looking mainly for the deeper tone and doesn't have to be loud but louder than my stock Akrapovuc exhaust

@RLS-Exhaust 4 месяца назад

This is the one by far my best exhaust yet.

@DanielPerez-vt5ez 5 месяцев назад

Always liked the lower tone over higher pitch mufflers. Sounds good to me.

@RLS-Exhaust 4 месяца назад

Sorry i don’t have a 600 is it will be a bit before i can get a clip with the 600 but I’m sure it sounds even better than the 900 i think that about all the the ryker exhaust models the 600 sounds better

@WarMach1ne664 3 месяца назад

@@RLS-Exhaust No problem, I’ll just ride my 600 on down.

@MrN1NNO 3 месяца назад

I have one on my Ryker 900 Sport and love it, I do have both baffles in, I was living in a 55+ apartment complex with a garage underneath the building where I kept the Ryker. I'm now in a house and might take out the outer baffle, but I can't get the 10mm bolt out😢

@RLS-Exhaust 3 месяца назад

Try heating the back up and then removing the bolt

@아가리또맘마 2 месяца назад

I'm a Ryker sports rider living in Korea. I think RLS is the best sound. Akrapovic in the Ryker rally edition is so quiet. I don't have luxury goods in stock right now, when can I buy them? And will the torque drop if I install them?

@RLS-Exhaust 2 месяца назад

I will start taking orders again in a few weeks materials arrived and i had about 100 exhaust to build this is a great performing exhaust no loss of torque

@WarMach1ne664 4 месяца назад

Any chance we can hear it on a 600?

@MrN1NNO 3 месяца назад

What size is the screw that you took out? Is it hex or tork screw?

@RLS-Exhaust 3 месяца назад

hex it is a 4mm

@MrN1NNO 3 месяца назад

Thank you very much, I did get the end baffle out, but not sure about the “loudness” of it yet. Dropped the screw into the muffler, so if I do decide to replace baffle I’ll have to figure out a replacement for that.

@RLS-Exhaust 3 месяца назад

@@MrN1NNO when purchasing a new bolt i would take the small baffle with you to the hardware store

@chadlivingston9646 2 месяца назад

I love the sound of this exhaust! This is your best sounding by far...imo. Is there any chance of the screw holding in the baffle vibrating loose while riding? I love the idea of being able to quiet it down a bit for when my wife is riding.

@RLS-Exhaust 2 месяца назад

No it shouldn’t vibrate out I have had no issues with mine