that's cause they don't have OSHA and EPA breathing down their back,,,,,,,,,with a 1000 different rules ...........they see a job and they go at it..........not like this wimp country.............did you see the electric cord for the grinder..........the one kid looking at the welder and no eye shield........no safety shoes.......and guess what? they're ALL STILL ALIVE.
so we can conclude that happiness is a function of what factor ?? no doubt is not driven by money. glamour . prestige . pretention ..or ?? spirituality!!
@@ershvv7567 а ну да, срезал фаски газом, смонтировано так что и не заметишь сразу.) Ходить такой ремонт безусловно будет, но все равно нормальной разделкой это назвать, у меня язык не поворачивается.
You should have grinded both pieces on a angle to get good weld penatration that weld is only on the top surface, wont last long. but didn't fix what caused the crack. Equalizer bar is shot, worn out needs to be repaired, or this will happen again
If you think that's quality work you have a screw loose!! One bead to weld in a 1" plate without any weld prep! Well at least they're saving welding rods!!
He didn’t do bevels, although at the end it looked like he torched them, but that’s not a clean seam to weld if he gas axed those in after tagging it in place already.